P1415 Code: Secondary Air Injection System (GM, Bank 1)
On General Motors vehicles (Chevrolet, GMC, Buick, Cadillac), the P1415 code means the secondary air injection system on bank 1 is not working as expected. You may hear the air pump after a cold start, or notice that it stays silent. Other brands may use this number for something else.
- Severity
- Low
- Can I keep driving?
- Yes, no immediate risk
- Estimated cost
- $80 to $700
- Difficulty
- Medium
- System
- Emissions Control
- Applies to
- Depends on the manufacturer
Common in: Chevrolet
On this page
What the P1415 code means
P1415 is a manufacturer-specific code: the 1 in the second position means each automaker defines what it means, not the generic SAE standard. The most widespread definition is the one used by General Motors (Chevrolet, GMC, Buick, Cadillac). If your vehicle is another brand, confirm the code text with a scan tool that supports that manufacturer.
| Manufacturer | Meaning of P1415 |
|---|---|
| General Motors (Chevrolet, GMC, Buick, Cadillac) | Secondary air injection system (bank 1) |
The GM secondary air system blows air into the exhaust after a cold start to warm up the catalytic converter faster.
The computer sets the P1415 code when, with the pump running, the bank 1 oxygen sensor does not detect the extra air. The pump, the valve or an air passage may be blocked.
Before you start repairs, confirm the make, model, year and engine. With manufacturer codes, the same number can change even between engines from the same brand.
P1415 code symptoms
- Check engine light on.
- Air pump noise after a cold start, or no noise at all when you expect it.
Likely causes of the P1415 code
- Stuck check valve or shutoff valve.
- Air pump failed from moisture getting into it.
- Air passages to the exhaust manifold blocked. Confirm it with the tests in the diagnosis section.
- Relay or fuse. Swap it with an identical one to rule it out.
How to diagnose the P1415 code step by step
- Start the engine cold and listen for the pump. It should run for a short time right after startup.
- Turn the pump and the valve on with the scan tool and watch whether they respond.
- Watch the oxygen sensor. It should read lean while the air is active.
How to fix the P1415 code
- Replace the valve or the pump.
- Clean the air passages.
Technical reference data
- The pump runs for 30 to 90 seconds after a cold start.
- P1xxx codes are manufacturer-specific: confirm the definition with a scan tool that supports your brand.
- Reference values: check the manufacturer data for your vehicle.
Brand-specific notes
A cold start is the best time to test this system, because that is the only time the pump normally runs.
P1415 on GM
Common on the Chevrolet Silverado, Tahoe, Suburban and Corvette.
If your vehicle is another brand, check the table above for the meaning its manufacturer gives this code and confirm it with a compatible scan tool.
Questions about the P1415 code
There are no questions about this code yet. Tell us about your case: vehicle, symptoms and what you have already checked.