P0862Generic code

P0862 Code: Gear Shift Module Communication Circuit High

The P0862 code means the communication line to the gear shift module is reading high, and the transmission computer has lost contact with it. The transmission may go into limp mode, or the shifter may stop responding. An open line or a short to voltage is the usual cause.

Severity
High
Can I keep driving?
Yes, but with caution
Estimated cost
$20 to $900
Difficulty
Medium
System
Transmission
Applies to
All OBD2 vehicles

Updated Reviewed by Renzo Chacca

On this page

What the P0862 code means

Some vehicles have a dedicated communication line to the gear shift module, in addition to the general CAN network. The shifter position, the shift commands and the transmission status travel over it.

The P0862 code is stored when that communication fails with a high signal. The transmission then does not receive or send essential information and activates limp mode. Check power and ground at both modules and the wiring between them. If other U codes are stored, resolve them first.

To confirm the diagnosis, measure the continuity of each wire between the component connector and the computer connector with the key off. It should be under 1 ohm, and an infinite reading means the wire is open. If the wiring is good, measure the component itself: an infinite resistance confirms it is open inside.

P0862 code symptoms

  • Transmission in limp mode.
  • The shifter does not respond or the gear indicator does not work.
  • Check engine light on.

Likely causes of the P0862 code

  1. Damaged communication wiring, either cut or shorted.
  2. Power or ground problem at one of the modules. A module with no power cannot communicate.
  3. Corroded connector, which raises the resistance of the line.
  4. Shifter module or transmission module with an internal fault.

How to diagnose the P0862 code step by step

  1. Check power and ground at both modules.
  2. Test the communication line for continuity and for the absence of shorts.
  3. Read related U codes.

How to fix the P0862 code

  • Repair the wiring or the connector.
  • Replace the faulty module.

Technical reference data

  • Dedicated communication line or CAN network, depending on the vehicle.
  • Reference values are only a guide, so look up the manufacturer data for your vehicle.

Brand-specific notes

On vehicles with an electronic shifter, the shifter module is the first suspect when you see a P0862 code.

P0862 on BMW

On BMW vehicles with an electronic shifter, the shifter module is the first suspect.

P0862 on Mercedes

On Mercedes vehicles with an electronic shifter, the shifter module is the first suspect.

P0862 on Jeep

On Jeep vehicles with an electronic shifter, the shifter module is the first suspect.

P0862 on Ford

On Ford vehicles with an electronic shifter, the shifter module is the first suspect.

Frequently asked questions about P0862

Can I drive with a P0862 code?
With caution. The transmission may go into limp mode, and the shifter may not respond, so get it checked soon.
What usually fails?
The wiring or one of the modules.
Does a new module need to be programmed?
Many times, yes.
How much does it cost to fix P0862?
Between $20 and $900, from a simple wiring repair up to replacing a module.
What does the P0862 code mean?
It is a generic OBD2 code that means the gear shift module communication circuit is reading high.

Related codes

Questions about the P0862 code

There are no questions about this code yet. Tell us about your case: vehicle, symptoms and what you have already checked.