P0992 Code: Transmission Fluid Pressure Sensor/Switch F Circuit

What the P0992 code means

Modern automatic transmissions measure fluid pressure in several circuits to confirm that each clutch actually receives pressure when its solenoid is commanded on.

The sensor gets a 5 volt reference and a ground from the computer and sends back a signal somewhere between about 0.5 and 4.5 volts. The P0992 code is a circuit fault, and it can come from the sensor, from the wiring or from the power supply to the sensor.

When the signal fails, the computer cannot confirm that the clutches are applying, and it usually puts the transmission in limp mode. On any transmission code, check the fluid first. The level has to be right using the manufacturer procedure, which often calls for the engine running at a specific temperature. The fluid should be red or pink and should not smell burnt. Low or worn fluid causes slipping, harsh shifts and solenoid or gear ratio codes that go away once the fluid is corrected.

Always start with the simple things: the fuse, the relay and the connector. Then check power, ground and signal with the component plugged in, using back-probes. Last, test the continuity of each wire all the way to the computer. Only when all of that checks out should you replace the sensor.

P0992 code symptoms

• Check engine light on.
• Transmission in limp mode.
• Harsh shifts or no shifts at all.

Likely causes of the P0992 code

1. Damaged or corroded connector. The most frequent cause.
2. Wiring cut or shorted between the sensor and the computer.
3. Failed sensor. Open, or shorted inside.
4. Missing reference supply. Check whether other sensors are also failing.
5. Computer. Uncommon, so rule out everything above first.

How to diagnose the P0992 code step by step

1. Read the sensor value on the scan tool and compare it with what you expect.
2. Inspect the connector for corrosion, water or loose pins.
3. Check power and ground with the key on: the reference should be correct and the voltage drop on the ground should be under 0.1 volt.
4. Measure the signal with the connector plugged in and see whether it changes with the condition.
5. Do a wiggle test on the harness with the scan tool in graph mode.
6. Check the continuity of each wire to the computer. It should be under 1 ohm.
7. Check the fluid level and condition.

How to fix the P0992 code

• Repair the connector or the wiring.
• Replace the sensor if the tests confirm it is bad.
• Correct the real condition if there is one.
• Clear the codes and verify the repair with a road test.

Technical reference data

• 5 volt sensor or pressure switch.
• These values are only a guide, so look up the manufacturer data for your vehicle.

Brand-specific notes

Check the service manual to see which pressure circuit matches the letter F on your transmission, because the lettering is not the same from one transmission to the next.

Frequently asked questions about P0992