P0608 Code: Control Module VSS Output A Malfunction

What the P0608 code means

The engine computer generates a vehicle speed A signal for other components: the speedometer, cruise control, the speed-sensitive volume radio or the tachograph. If the output circuit is shorted or open, those components stop receiving the information.

On modern vehicles this information travels over the CAN network, and the P0608 code usually points to a problem in the dedicated circuit that some equipment still uses (radio, tachograph, accessory modules).

Always start with the simplest things: fuse, relay and connector. Then check power, ground and signal with the component connected (using back-probe pins), and finally the continuity of each wire to the computer. Only replace the component if all of that checks out.

P0608 code symptoms

• Failure of the components that use the signal (the speedometer, cruise control, the speed-sensitive volume radio or the tachograph).
• Check engine light on.

Likely causes of the P0608 code

1. Output circuit shorted to ground or to 12 V from the wire rubbing.
2. Receiving component with an internal short. It loads down the signal.
3. Damaged connector: loose, broken or corroded.
4. Badly installed accessory that loads down the signal.

How to diagnose the P0608 code step by step

1. Unplug the components that receive the signal and check whether the code goes away.
2. Measure the signal at the computer output with an oscilloscope.
3. Inspect the wiring.

How to fix the P0608 code

• Repair the wiring or the receiving component.
• Remove badly installed accessories.
• Clear the code and verify.

Technical reference data

• Pulse or voltage signal, depending on the manufacturer.
• Reference values only: check the manufacturer data for your vehicle.

Brand-specific notes

Accessories installed after the sale (alarms, trackers, radios) are a frequent cause.

Frequently asked questions about P0608