P0567Generic code

P0567 Code: Cruise Control Resume Signal

The P0567 code means the computer sees a fault in the signal from the cruise control switches, specifically the RESUME signal. Cruise control is disabled, and the rest of the vehicle works normally. The steering wheel clockspring is the first suspect.

Severity
Low
Can I keep driving?
Yes, no immediate risk
Estimated cost
$20 to $400
Difficulty
Medium
System
Idle and Speed Control
Applies to
All OBD2 vehicles

Updated Reviewed by Renzo Chacca

On this page

What the P0567 code means

The cruise control switches, on the steering wheel or on a stalk, send their commands to the computer through one or more wires. Many manufacturers run a single line with a different resistance for each button, and the computer reads which button is pressed from the voltage it sees.

The P0567 code means the computer sees a signal that does not match any button, a signal that sticks as if a button were held down all the time, or a signal that disagrees with the second control line. To be safe, it shuts cruise control off.

The most frequent cause is the steering wheel clockspring, which links the buttons to the vehicle through a ribbon that wears as the wheel turns. Dirty buttons or spilled liquid are another common cause.

Always start with the simple things: fuse, relay and connector. Next check power, ground and signal with the component connected (using back-probe pins), and finally the continuity of each wire to the computer. Replace the component only when everything else is fine.

P0567 code symptoms

  • Cruise control that does not work.
  • Check engine light or cruise control light on.
  • In some cases the horn or the steering wheel buttons also fail (clockspring).

Likely causes of the P0567 code

  1. Damaged steering wheel clockspring. The ribbon inside breaks with use.
  2. Steering wheel buttons that are dirty or damaged by spilled liquids.
  3. Control module connector with a loose, intermittent contact.
  4. Brake switch, if it affects the cancel signal.

How to diagnose the P0567 code step by step

  1. Watch each button on the scan tool as you press it. Only the button you are pressing should change state.
  2. Measure the switch resistance in every position and compare it with the manufacturer table.
  3. Check the clockspring if the horn, the airbag light or the steering wheel buttons also fail.
  4. Check the brake switch.

How to fix the P0567 code

  • Replace the clockspring or the steering wheel controls.
  • Clean the button contacts.
  • Repair the wiring.
  • Clear the code and test cruise control.

Technical reference data

  • Switches built as a resistor ladder: each button produces a different voltage on the same line.
  • Reference values only: check the manufacturer data for your vehicle.

Brand-specific notes

When working on the steering wheel, disconnect the battery and give it a few minutes first. The driver airbag could deploy.

P0567 on Ford

On many Ford vehicles the clockspring is a common failure.

P0567 on GM

On many GM vehicles the clockspring is a common failure.

P0567 on Chrysler

On many Chrysler vehicles the clockspring is a common failure.

Frequently asked questions about P0567

Can I drive with the P0567 code?
Yes. It only affects cruise control. The engine, brakes and the rest of the vehicle work as normal, so it is not a safety problem on the road.
What is the clockspring?
It is a ribbon wound inside the steering column that connects the airbag and the buttons to the vehicle even when the steering wheel turns. Once it wears out, the buttons quit.
Is it dangerous to take off the steering wheel?
Yes, because of the airbag. Follow the manufacturer procedure, disconnect the battery and wait before you touch anything.
How much does it cost to fix P0567?
It runs from $20 to $400. Cleaning a contact or repairing a wire is cheap, while a clockspring or new steering wheel controls cost more.
What does the P0567 code mean?
The P0567 code is a generic OBD2 code for a fault in the cruise control RESUME signal. The computer rejects the switch signal and turns the system off.
What is the most common cause of P0567?
A worn clockspring in the steering wheel. After that come dirty buttons and a loose connector.

Related codes

Questions about the P0567 code

There are no questions about this code yet. Tell us about your case: vehicle, symptoms and what you have already checked.